In-Stock Outdoor Dacron Foam Sheets

Outdoor Dacron Foam

Drain Dry Foam

Dryfast foam also known as EZ-Dry is our most popular outdoor foam seat, back and mattresses cushion applications. With open pores, this foam has a 1 to 3 hour drying time and can be left outside all the time. To make the foam last longer it is best to storage the foam when it is not in use.

As low as $10.85
In stock
SKU
50-ild-for-seat-back-cushions

This outdoor foam has an open-cell structure and is perfect for areas where your cushions get wet. It dries almost immediately after exposure to rain, salt spray, melting snow, morning dew, washing, or other types of moisture and humidity. Large, open pores permit maximum water drainage and air circulation, allowing quick use after being wet or even saturated. Drain Dry Foam combines both comfort and durability along with extremely fast drying properties.

Water easily passes through this EZ-Dry polyurethane foam.
Recommended for:
* Outdoor furniture such as seats, back cushions, and mattresses.
* Boat or marine cushions, golf carts, pool, patio, or grading cushions.
* Can also be used under Phifertex material for filtering or padding whatever is exposed to large amounts of water.
* Any type of padding that is exposed to large amounts of water.

Here are a few additional advantages of Drain Dry Foam:

It Sheds Water Like A Sieve yet provides seating comfort. has large, open pores (reticulation), permits rapid draining, and maximum air circulation for fast drying.

It has a unique proprietary formulation that enhances its strength and durability for long-term exposure to the sun and inclement weather.

It is resistant to most chemicals including many cleaning agents, solvents, alkalies, and acids (bleach may cause rapid discoloration).

It has a built-in fungicidal additive that inhibits fungus and mildew which is important for retarding stain and odor.

You can compound shapes for even the most unusual cushion designs. 

Available Thickness: 1/2", 1", 2", 3", 4", 5", 6"

Available Sizes:
50″ x 116″
25 ” x 116″
50″ x 58″
25″ x 58″

This foam is not UV-sun resistant because it all depending on how hot the weather is and how long its been out in the sun for, the foam may deteriorate. For a long lasting foam please make sure that you keep the foam covered at all time or keep it in doors when not in used.

Best way to cut the open cell foam is with a sharp knife or electric turkey knife, just repeat in 1 direction over and over again in one direction to get a clean cut. Please note that if you order these size sheets they may be bigger than actual size as listed.

Please note: When comparing different types of foam with other companies it is most important to look at the density and ILD of the foam.

Foam density is a specific measurement of how much weight in pounds polyurethane foam can handle per cubic foot. This density rating tells you the strength of the foam. The height the number the longer the foam will last. It should not be used exclusively as a sign of durability or comfort, because firmness and lifespan of foam products like mattresses and cushions, depend on many factors, including density. The density may vary slightly between each foam shipments.

ILD or IFD measurement firmness of how hard or soft a foam is. The higher number the foam is, the firmer the foam is. Also represents how many pounds the foam will hold before it collapse. If you take a block of foam 12″ x 12″ x 12″ cube, after the certain ILD is reach that foam will collapse.

We vacuum pack the foam to reduce on shipping cost. you will have to give the foam 1-2 days to come back to its original shape. It will look a little misshaped and not measure to correct size until after you let it expand back out.